Surface Fixed
Djembes
Page 1 of 2
1. Assemble Ground Fixing Posts to base of sambas using M8x25mm security screws and lock washers. (1.1)( See Assembly Guide)

Ground Surface Installation Instructions

Djembes will arrive on site in pre set heights. (1.1)
48 Kg 1.5m
Install Instrument with 1.5m free space (from widest point) around it.
Played with hands
Surface Fix
Components:
M8x25 Security Screwx18
M8 Lock Washerx18
Weight of heaviest part 23kg
(Large Djembe)
BS EN 1176
500mm

Spares available from percussionplay.com or from your local distributor

2.Arrange Djembes in desired location and mark holes to fix to desired surface.
3. Fix to Surface using recommended ground anchors (Ground Anchors are not supplied)
4. Make sure all fixings are covered and secure using cover caps provided

Instrument Components:
Djembes are pre-assembled
CAUTION: Drum surface can get hot in direct sunlight, if possible install in shaded areas.

Surface Fixed
Assembly Guide PPDJEM
44 Kg
Played with hands
Djembes
Page 2 of 2
TX 40 Driver Bit
Tools:
x1 BS EN 1176
Spares available from percussionplay.com or from your local distributor
M8x25 Security Screw
x18 M8 Lock Washer
x18 2 Part Cover Cap
x9 Instrument

Components:
Djembes are pre-assembled
M8x25 Pin torx X18
M8 Lock washer X18
COMPONENTS LIST:
2 Part Cover Cap X9

Surface Fixed
Components:
Ground Fix Installation
(1.1)
M8 Lock Washerx18
M8x25mm Pin Torx18

Djembes
Page 3 of 4
BS EN 1176
TX 40 Driver Bit
Tools:
x1 Attach Ground Fix Legs to base of each drum using M8x25 Bolts and lock washers provided.

Excavate 3 holes 350mm deep. Each hole should taper down making the base diameter at least 100mm larger than the surface
hole

Compact each hole with a maximum of 50mm of aggregate and lower each samba into its hole

Surface Fixed Components:
Ground Fix Installation (1.1)
M8 Lock Washerx18
M8x25mm Pin Torx x18
Djembes
Page 4 of 4
BS EN 1176
Foundations should not present a hazard. These foundations are recommended as a guide, for more information on foundation details for various surface see Part 1 of BS EN 1176.
Metric Conversion:
50mm/ 2”
350mm/ 14”
500mm/ 19.5”
550mm/ 21.5”
600mm/ 24”
650mm/ 25.5”
700mm/ 27.5”