Surface Fixed Harmony Bells
Page 1 of 2
Surface Fixed Installation Instructions
1. Unpack ground fixing legs (3no.)
2. Lay packaging out on floor or assemble on non-abrasive surface to prevent marking of polished stainless steel.
3. Align holes on legs to holes on surface fixing(opposite end to polished domes) and secure in place using 3no. M10 x 30mm Screws provided.
Tools required TX 45 Driver Bit
4. Invert assembled frame so Bells are at the top.
5. Locate Bells in desired location and mark holes to fix to desired surface
6. Fix to Surface using recommended ground anchors (Ground Anchors are not supplied)
7. Make sure all fixings are covered and secure using cover caps provided
NB: Install Instrument with 1.5m free space (from widest point) around it.

Instrument Components:
Small Beaters X3
Surface Fix Components:
M10x30 Security Screw x3
2 Part Cover Cap x4
Ground Anchors not supplied
Metric Conversion: 1650mm/ 64 61/64โ€ 1.5m/ 59โ€


Instrument Weight: 30Kg
Weight of heaviest part 8kg (Large Bell)
BS EN 1176
Spares available from percussionplay.com or from your local distributor


Surface Fixed Harmony Bells
Page 2 of 2
Assembly Guide PPHARMB
1. Locate the Surface fix Plate into the leg of the instrument. (Thread Lock Solution Required)
2. Fix instrument to Surface fix plate using M10 Screws and use thread locking solution to prevent fixings working loose.
3. Fix Surface Plate to the ground surface Ground Anchors Not provided. Cover fixings with caps provided

Instrument Components:
Small Beaters X3
Surface Fix Components:
M10x30 Security Screwx3
2 Part Cover Capx4
Ground Anchors not supplied
Tools: TX 45 Driver Bit x1

Instrument Weight: 30Kg

Spares available from percussionplay.com or your local distributor