Harmony Flowers
Surface Fixed Installation Instructions
Page 1 of 2
1. Unpack ground fixing leg 1no.
2. Lay packaging out on floor or assemble on non-abrasive surface to prevent marking of polished stainless steel.
3. Align holes on leg to holes on surface fixing plate
(opposite end to polished domes) and secure in place using 1no. M10 x 40mm Screw and Barrel Nut provided. Tools required TX 45 Driver Bits)
4. Invert assembled frame so Bells are at the top.
5. Locate Flower in desired location and mark holes to fix to surface.
6. Fix to Surface using recommended ground anchors (Ground Anchors are not supplied)
7. Make sure all fixings are covered and secure using cover caps provided

N.B: Install Instrument with 1.5m free space from widest point around it.

Instrument Components:
Small Beaters x 1
Surface Fix Components
M10x40 Security Screw x1
M10 Barrel Nut x1
2 Part Cover Cap x4
Spares available from percussionplay.com or from your local distributor
Ground Anchors not supplied
Metric Conversion: 1345mm/ 52 61/64โ€ 1095mm/ 43 7/64โ€ 945mm/ 37 13/64โ€ 1.5m/ 59โ€
Made in Britain
BS EN1176
Weight: 9 Kg
Weight of heaviest part 6kg (Surface Plate)

Harmony Flowers
Surface Fixed Installation Instructions
Page 2 of 2
Assembly Guide PPHARMB
1. Locate the Surface fix Plate into the leg of the instrument.
2. Fix instrument to Surface fix plate using M10 Screws and use thread locking solution to prevent
3. Fix Surface Plate to the ground surface Ground Anchors Not provided - cover fixing with caps provided.
Instrument Components:
Small Beaters x1
Surface Fix Components:
M10x30 Security Screw x3
2 Part Cover Cap x4
Ground Anchors Not Supplied
Spares available from percussionplay.com or your local distributor
Weight of Instruments: 9Kg
Made in Britain
BS EN1176