Harmony Flowers
Surface Fixed Installation Instructions
Page 1 of 2
1. Unpack ground fixing legs 3no.
2. Lay packaging out on floor or assemble on non-abrasive surface to prevent marking of polished stainless steel.
3. Align holes on legs to holes on surface fixing(opposite end to polished domes) and secure in place using 3no. M10 x 30mm Screws provided. Tools required TX 45 Driver Bit)
4. Invert assembled frame so flowers are at the top.
5. Locate Flowers in desired location and mark holes to fix to desired surface.
6. Fix to Surface using recommended ground anchors (Ground Anchors are not supplied)
7. Make sure all fixings are covered and secure using cover caps provided
Install Instrument with 1.5m Free Space (from widest point around it)
Instrument Components:
Small Beaters x3
Surface Fix Components:
M10x30 Security Screw x3
2 Part Cover Cap x4
Ground Anchors Not Supplied
Spares available from percussionplay.com or your local distributor
Weight of heaviest part 6kg (Surface Plate)
Weight of Instruments: 21Kg
Metric Conversion: 1100mm/ ”
1.5m/ 59”
Made in Britain
BS EN1176


Harmony Flowers
Surface Fixed Installation Instructions
Page 2 of 2

1. Locate the Surface fix Plate into the leg of the instrument.
2. Fix instrument to Surface fix plate using M10 Screws and use thread locking solution to prevent fixings working loose.
3. Fix Surface Plate to the ground surface. Ground Anchors Not provided - Cover fixings with caps provided.
Ground Anchors not supplied
Thread Lock Solution Required

Instrument Components:
Small Beaters x3
Surface Fix Components:
M10x30 Security Screw x3
2 Part Cover Cap x4
Ground Anchors Not Supplied
Spares available from percussionplay.com or your local distributor
Weight of heaviest part 6kg (Surface Plate)
Weight of Instruments: 21Kg
Metric Conversion: 1100mm/ ”
1.5m/ 59”
Made in Britain
BS EN1176