Surface Fixed Sansa Rimba
Installation Instructions

1. Attach the steel legs to the base of the instrument with the MS Nyloc Nuts and 2 part security caps. ( 1.1) (See
Assembly Guide)
2. Attach Surface Fixing posts to legs( 1.2) (See Ground Fix Post Installation Sheet)
3. Locate Plate in desired location and mark holes to fix to desired surface.
4. Fix to Surface using recommended ground anchors not supplied
5. Make sure all fixings are covered and secure using cover caps provided
6. Attach the 1 pair of beater to the saddle strap on the leg. (1.3)

Instrument Components:

Sansa Rimba (pre-assembled)
M6x20 Security Screw x2
M8 Nyloc Nut x4
2 Part Cover Cap x4
M6 Saddle Strap x1
M10x70 Security Screw x1
M10 Barrel Nut x1
2 Part Cover Cap x4
Assembly Guide: Components List

2 Part Cover Cap X8
M8 Nyloc nut X4
M10 Nut X4
M10x200 Threaded Bar X2
Saddle Strap X1
M6x20 Pin torx X2
M10x70 Pin torx X1
M10 Barrel Nut Pin torx X1
Surface Fix Post Installation

1. Locate the Surface fix Plate into the leg of the instrument.
2. Fix instrument to Surface fix plate using M10 bolt and Barrel Nut and use thread locking solution to prevent fixings working loose.
3. Fix Surface Plate to the ground surface Ground Anchors Not provided cover fixings with caps provided.

Ground Anchors not supplied.
Install instrument with 1.5m free space (from widest point) around it.
Spares available from percussionplay.com or from your local distributor.